The program has not been loaded into the control, and it has not been selected as the active program. Instead of "INPUT" blinking, we get a message "Program has been verified" and nothing happens. We enter the program number and press O SET. So we enter the file number of the program we want (in this case, 0005). In this screen, the programs loaded on the card are listed sequentially by their file number. The control is in edit mode, we are already in the memory card screen. When the read operation ends, the INPUT indication disappears. This starts reading the program, and INPUT blinks in the lower right part of the screen. Type a program number, and press the soft key O SET Set the program number to be used after the input. Type a file number, and press the soft key F SETĥ. Set the file number that you want to input. Press edit switch or enter state emergency stopĤ. A program can be input and output using the memory card screen.ġ. I'm trying to figure out how to load programs from a memory stick onto the CNC memory. I've read the chapters on program I/O in the user's manual about a dozen times.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |